Maintenance kit (batteries maintenance and maintenance)

1, the cell surface, links and bolts should be clean and dry to maintain long-term. If electrolyte application of clean cotton yarn to, and comprising dry-clean water. Note : in the cleansing process, no access to tap water batteries, to prevent leakage and increase self discharge, failure to operate the vehicle.

2, the cells must maintain good links. Regular inspection of the cell line initiative nut or relaxed to avoid spark or burn very pillars.

3, batteries placed on the exclusion of any goods, shall not cathode battery is directly linked to avoid short-circuit, damage cells.

4, batteries discharged after (whether vehicles time and mileage), the day must be charged, not more than 24 hours a day charging or charging. Otherwise battery life will be affected.

5, the use of batteries in the process of the electrolysis of water in the electrolyte and evaporation will rise and cause density gauges decline (especially in the summer), it should be constantly add electrolyte or distilled water. Batteries in the charging terminal, or use distilled water for the density of 1.400-acid batteries for Xiliusuan adjustment electrolyte density of 1.280+0.005 (25 degrees), liquid line with the highest reading level. Adjusted to continue charging 0.5-1 hours to internal homogeneous.

6, batteries, not fall into any impurities. Plus water used to clean equipment should be maintained to avoid impurities into the cell.

7, if the vehicles do not have long, full of electricity, batteries should be stored, and every half a month to a charge, charging time about nine hours.

8, the useful life of batteries generally one to one and a half hours, when the battery capacity will be drastically reduced, the time required to replace batteries. Must be the same brand, same size, voltage similar (with electricity, the margin does not exceed the maximum voltage 0.1V) batteries for the group.

(controller maintenance and maintenance) regular maintenance

1, check whether the contacts between good contacts with contacts, the availability of conglutination, points of contact have died mechanical card

2, Inspection accelerator, micro-switches communication, the performance is definitely good

3, inspection direction switches communication, performance is definitely good

4, check electrical, batteries are good links between the group and controls. Note : in the case of electricity, an inspection at least three months in arrears. Shun water rinse electrical pieces! Can use brushes or high pressure gas removal.